I used the mirror in the bathroom with the Leap Motion connected to my laptop.Ĥ.Install Arduino IDE: Click here to downloadĥ.Install Node.js: Click here to downloadġ-Open terminal (Cmd + SPACE > “terminal” > press enter)ġ-In terminal type “node -v” > press enterĢ-If you see something like “v8.9.3” then you are good to goģ-If you see something like “-bash: npp: command not found” then you need to install Node.jsġ-In terminal type “npm -v” > press enterĢ-If you see something like “5.5.1” then you are good to goģ-If you see something like “-bash: npp: command not found” then you need to install npm. If you do, ideally you should have the Leap Motion surface very clean and you should also have a clean mirror available. Install Leap Motion Desktop Software: Download Desktop Appġ-Open Leap Motion (Cmd + SPACE > search “Leap Motion”)Ģ-Click on Leap Motion icon at top of page > click on settingsģ-Verify that your settings match those in the pictures included:Ĥ-Calibrate if needed. Please note that these wires are where you should connect your separate power supply for the servos. Option 2: Old power supply with the following specs: DC Between 5V and 7V Greater than 3A to sufficiently power all servosĥ.The diagram attached, is to show you the basic connection of the servos to the Arduino.You can see that there are two wires (black and red) extending to the right from the prototyping PCB. I don’t recommend MG995 or servo with plastic gears!) Step 2: Build InMoov Hand and Forearm Step 3: Connect the Wiresįor this part you’ll need the following components/tools/supplies:Ģ.(1)NervoBoard ( nervo-board-tutorial) or a servo shieldģ.(5) x HK15298 Servos (These servos are nice.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |